Using Node-RED#

Node-RED provides a browser-based editor that makes it easy to wire together flows using the wide range of nodes in the palette that can be deployed to its runtime in a single-click.

Pre-requisites#

Note

If you’re using the official BeaglePlay debian image then you most likely can skip the Node-RED step.

Node-RED#

Node-RED is pre-installed with the bb-node-red-installer package. (both xfce and cinnamon) Manual steps to install Node-RED can be found in the official guide here

MikroE#

MikroE Accel click is recommended, but many other boards can work. More information about the mikroBUS interface can be found here.

Let’s get started!#

First, we want to make sure the mikroBUS™ add-on board is connected and functioning as expected. To do this, we make use of the iio_info command.

Connecting mikroBUS™ add-on board#

iio_info is a utility for displaying information about local or remote IIO devices, in this case it’s the Accel click board.

../../../_images/iio_info_out.png — Fig. 204 iio_info command output#

Accessing Node-RED#

Once your BeaglePlay is booted up and connected to your computer, access it from your browser by typing 192.168.7.2:1880 in your address bar. Learn more about remote browser in Browse to your Beagle.

Creating a basic flow#

In this flow we’ll take a look at how we can get the accelerometer readings output on the node red console.

First, let’s insert the exec function block. This will help us capture a linux command from an entry like /sys/bus/iio/....

Double click on the function block and in the command paste:

cat /sys/bus/iio/devices/iio\:device0.../in_accel_x_raw

Give it some name and press Done.

Next, we add the “Debug” node and connect it to the previous function block we made to get the output.

Optionally, as shown in the video we can also “Inject” a timestamp into the function block which will then go into the debug console to give us the logs with timestamps.